Clostridium Difficile Toxin A Or B ELISA 试剂盒
适用: Clostridium difficile
Colorimetric
Sandwich ELISA
Fecal
1 image
(6 references)-
- 抗原
- Clostridium Difficile Toxin A Or B
- 适用
- Clostridium difficile
- 检测方法
- Colorimetric
- 实验类型
- Sandwich ELISA
- 应用范围
- ELISA
- 原理
- ELISA for the separate detection of Clostridium difficile Toxin A OR Toxin B in suspensions
- 样品类型
- Fecal
- Analytical Method
- Quantitative
- 灵敏度
- 0.5 ng/mL
- 组件
-
- 1x ELISA Plate 12x8 stripes
- 1 x 50 mL dilution buffer
- 1 x 2.0 mL Standard control Toxin A&B
- 1 x 7 mL conjugate
- 1 x 30 mL 10x washing buffer
- 1 x 14 mL substrate
- 1 x 7.5 mL stop solution with 0.5 M H2SO4
- 1x Manual
-
- 应用备注
- Sensitivity of the test is 0,5 ng/ml for TcdA as well as for TcdB.
- 板类型
- Pre-coated
- 实验流程
-
- Prepare 1x Wash Buffer: the Wash Buffer is supplied as a 10x concentrate. The 30 ml supplied need to be diluted to a total volume of 300 ml by adding 270 ml distilled water. Preparation of aliquots of the Wash Buffer is done accordingly. Store your diluted 1x Wash Buffer between 2 °C and 8 °C to avoid growth of contaminating microbes.
- Microtitre plate: the plates are sealed in aluminum bags that need to be resealed once opened. Before starting determine the number of wells to be used. Do not contaminate the wells with your fingers. The plates can be used as broken “single wells” or in form of single strips. Each strip contains 8 wells coated with antibodies specific for C. diff. toxin A and oxin B. Assay wells not used should immediately be returned to the bag and carefully resealed with desiccant. After opening stability of plates at 4 °C will be about 6 months.
- Choose your conjugate properly: for the detection of toxin A use the anti-toxin A-HRP conjugate for the detection of toxin B use the anti-toxin B-HRP conjugate as supplied in separate solutions. The conjugate is ready to use. For each well you need 50 µl.
- 样品制备
-
- Important notes before starting:
- If the ELISA procedure should follow the one step protocol (see "Assay Procedure"), it is essential that the test sample is totally free of PBS.
- To avoid high background reactions resulting from mixing of PBS and conjugate, the two step protocol is strongly recommended. In this case, the anti toxin A or BHRP conjugate has to be prediluted with two parts dilution buffer (for example, 100 μl of the anti toxin A or B-HRP conjugate with 200 μl dilution buffer).
- Sample Preparation:
- Culture supernatant: Centrifuge the C. difficile culture at 2500 G for 2-5 minutes and dilute the supernatant 1:2 to 1:10 in Dilution Buffer.
- Colonies: For testing colonies from freshly grown agar plates remove app. 5 colonies or 1 cm² of a confluent plate and resuspend the bacteria in 0,5 ml Dilution Buffer. Homogenize the suspension by vortexing and centrifuge the sample at 2500 G for 2-5 minutes. The supernatant can be used directly without further dilution.
- Stool sample: Transfer about 50 μl liquid stool sample or take an equivalent amount (50 mg) of compact stool in 450 μl dilution buffer, homogenize the suspension by suction and ejection from a disposable pipette or by vortexing. After leaving for a short time to allow sedimentation of stool particles the clarified supernatant can be used directly in the test. Automated equipment may be used with specimen that have been centrifuged 5 min by 2500 x g to remove any particulate matter.
- Standard control: An example for routinely used dilutions of the standard control toxins is given in the diagram below.
- Important notes before starting:
- 实验流程
-
- Section 1 (Choose between one or two step protocol, then continue with section 2 of protocol)
- A: One Step Protocol
- Pipette 100 μl of the prepared specimen or the control toxin (for a calibration the controls have to be prediluted) into each single well. A diagram showing the dilutions routinely used for toxin A and toxin B calibration is attached. As negative control use 100 μl of the Dilution Buffer.
- Add 50 μl of the anti-toxin A-HRP conjugate to detect toxin A OR 50 μl of the anti-toxin B-HRP conjugate to detect toxin B to each well. After the addition of the conjugate pipette once up and down to mix the components.
- Incubate specimen plus conjugate for 60 min at 37 °C.
- Continue with section 2 of the protocol.
- B: Two Step Protocol
- Pipette 100 μl of the prepared specimen or the control toxin (for a calibration the controls have to be prediluted) into each single well. A diagram showing the dilutions routinely used for toxin A and toxin B calibration is attached. As negative control use 100 μl of the Dilution Buffer.
- Incubate for 60 min at 37 °C.
- Wash each well 3 x with Wash Buffer. After each washing, completely remove any residual liquid by striking the plate (wells) onto a dry paper.
- Add 100 μl of the anti toxin A OR B-HRP conjugate (prediluted with two parts dilution buffer) to each well to detect toxin A or toxin B.
- Incubate for 30 min at 37 °C.
- Continue with section 2 of the protocol.
- A: One Step Protocol
- Section 2
- Wash each well 3 x with Wash Buffer. After each washing step, completely remove any residual liquid by striking the plate (wells) onto a dry paper.
- Thereafter add 100 μl substrate to each well.
- Incubate for 15 min at RT.
- The color development will be stopped by adding 50 μl Stop solution to each well.
- Measurement of the extinction will be done with a microtiter plate photometer at 450 nm versus 620 nm.
- Section 1 (Choose between one or two step protocol, then continue with section 2 of protocol)
- 结果分析
-
- Read out: The read out of the assay is based on the measurement of the optical density at 450 nm and 620 nm and is calculated as OD450-OD620.
- Negative control: The OD450-620 of the negative control should be below 0,100.
- Standard controls: The standard control toxins are recombinant toxins with a concentration of 80 ng/ml (equivalent to the native C. difficile toxins) as determined by the method of Bradford.
The standard toxins can be used as a ready to use positive control OR to generate a calibration curve as exemplified in the diagram below. - Cut off value: Test reaction > 3 fold background reaction. For example, with a negative control value of OD450-620 0,030 the cut off is 0,120.
- 限制
- 仅限研究用
-
- 注意事项
-
- All reagents and materials which come into contact with potentially infectious samples must be treated with suitable disinfectant or autoclaved
- Suitable disposable gloves must be worn during the entire test.
- All reagents should be at room temperature prior to use.
- 储存条件
- 4 °C
- 储存方法
- After opening stability of plates at 4 °C will be about 6 months.
- 有效期
- 6 months
-
-
: "ADS024, a Bacillus velezensis strain, protects human colonic epithelial cells against C. difficile toxin-mediated apoptosis." in: Frontiers in microbiology, Vol. 13, pp. 1072534, (2022) (PubMed).
: "Lactotrehalose, an Analog of Trehalose, Increases Energy Metabolism Without Promoting Clostridioides difficile Infection in Mice." in: Gastroenterology, Vol. 158, Issue 5, pp. 1402-1416.e2, (2020) (PubMed).
: "A pilot study to assess bacterial and toxin reduction in patients with Clostridium difficile infection given fidaxomicin or vancomycin." in: Annals of clinical microbiology and antimicrobials, Vol. 15, pp. 22, (2016) (PubMed).
: "Evaluating the Effects of Surotomycin Treatment on Clostridium difficile Toxin A and B Production, Immune Response, and Morphological Changes." in: Antimicrobial agents and chemotherapy, Vol. 60, Issue 6, pp. 3519-23, (2016) (PubMed).
: "Impact on toxin production and cell morphology in Clostridium difficile by ridinilazole (SMT19969), a novel treatment for C. difficile infection." in: The Journal of antimicrobial chemotherapy, Vol. 71, Issue 5, pp. 1245-51, (2016) (PubMed).
: "The SOS Response Master Regulator LexA Is Associated with Sporulation, Motility and Biofilm Formation in Clostridium difficile." in: PLoS ONE, Vol. 10, Issue 12, pp. e0144763, (2015) (PubMed).
-
: "ADS024, a Bacillus velezensis strain, protects human colonic epithelial cells against C. difficile toxin-mediated apoptosis." in: Frontiers in microbiology, Vol. 13, pp. 1072534, (2022) (PubMed).
-
- 抗原
- Clostridium Difficile Toxin A Or B
- 背景
-
C. difficile is an opportunistic anaerobic bacterium that grows in the intestine once the normal flora has been altered due to treatment with antibiotics. Subsequently, many patients develop gastrointestinal problems ranging from mild diarrhea to severe pseudomembranous colitis.
The clinical symptoms associated with the disease are believed to be primarily due to the tissue-damaging enterotoxin A (TcdA), whereas the cytotoxin (TcdB) is the one detected by the cell culture cytotoxicity assay.
Most strains produce both toxins, although clinically relevant toxin A negative/toxin B positive strains have been isolated with increasing frequency worldwide. Laboratory diagnosis of C. difficile infection is most commonly performed in a two-step algorithm: (1) screening of C. difficile presence using an immunoassay for the detection of C. difficile glutamate dehydrogenase (GDH) followed by (2) assaying the presence of toxins A/B using either an immunoassay and/or by PCR based techniques, the latter especially important in cases where the GDH test is positive but the toxin ELISA results negative. This could be the case for toxin production below the detection limit or capture of toxins by antitoxin antibodies.
-
You are here:
