小鼠 IgG3 isotype control (Orange Cytognos 515)
-
- 抗原 See all IgG3 products
- IgG3
-
宿主
- 小鼠
- 标记
- Orange Cytognos 515
- 应用范围
- Flow Cytometry (FACS), Isotype Control (IsoC), Immunofluorescence (IF)
- 产品特性
- This mouse monoclonal IgG3 was produced against a synthetic hapten, which is normally not present in humans or animals. Therefore, this mouse IgG3 does not react with any antigen of human or animal cells.
-
克隆位点
- PPV-07
- 亚型
- IgG3
-
Mouse IgG3 isotype control (PE)
FACS, ELISA Monoclonal B10 IgG3 PE
Mouse IgG3 isotype control (FITC)FACS, ELISA Monoclonal B10 IgG3 FITC
Mouse IgG3 isotype control (SPRD)FACS, ELISA Monoclonal B10 IgG3 SPRD
Mouse IgG3 isotype control (APC)FACS, ELISA Monoclonal B10 IgG3 APC
Mouse IgG3 isotype control (Biotin)FACS, ELISA Monoclonal B10 IgG3 Biotin
Mouse IgG3 isotype control (PE-Cy7)FACS, ELISA Monoclonal B10 IgG3 PE-Cy7
Mouse IgG3 isotype controlFACS, ELISA Monoclonal B10 IgG3 unconjugated
Mouse IgG3 isotype controlFACS, ELISA, IsoC, IHC Monoclonal B10 IgG3 unconjugated
Mouse IgG3 isotype control (HRP)FACS, ELISA, FLISA Monoclonal B10 IgG3 HRP
Mouse IgG3 isotype control (Alkaline Phosphatase (AP))FACS, ELISA, FLISA Monoclonal B10 IgG3 Alkaline Phosphatase (AP)
-
- 应用备注
- It is recommended for use in flow cytometry. This reagent is effective for direct immunofluorescence staining of human tissue for flow cytometric analysis using 5 µL/10^6 cells.
- 说明
-
OC515 (Abs/Em Max: 405/518 nm) Direct replacement for: Pacific Orange and AmCyan.
- 样品收集
- 1. Transfer 100 µL of anticoagulated (EDTA) blood to a 12 x 75 mm polystyrene test tube (10^6 cells). 2. Add 5 µL of Isotype Control IgG3 OC515 and mix gently with a vortex mixer. The 5 µL is a guideline only, the correct volume depends on the quantity of direct monoclonal used. 3. Incubate in the dark at room temperature at 4 °C for 30 minutes or at room temperature (20-25 °C) for 15 minutes. 4. Add 1,5 mL of Lysing Solution to each sample and mix gently with a vortex mixer. Incubate for 10 minutes at room temperature in the dark. 5. Centrifuge at 1000 x g for 5 minutes. Gently aspirate the supernatant and discard it leaving approximately 50 µL of fluid. 6. Add 2 mL 0.01 mol/l PBS (It betters that it containing 2 % bovine serum albumin) and resuspend the cells by using a vortex mixer. 7. Centrifuge at 1000 x g for 5 minutes. Gently aspirate the supernatant and discard it leaving approximately 50 µL of fluid. 8. Resuspend pellet in an appropriate fluid for flow cytometry, e.g. 0.3 mL PBS. The PBS should contain 1 % paraformaldehyde (fixative) if samples are not analysed the same day. 9. Analyse on a flow cytometer or store at 2-8 °C in the dark until analysis. Samples can be run up to 24 hours after lysis.
- 限制
- 仅限研究用
-
- 状态
- Liquid
- 缓冲液
- The conjugate is provided in liquid form in buffer containing Antibody Stabilizer, PBS 20 mM and 0,09 % Sodium azide, pH 7.4.
- 储存液
- Sodium azide
- 注意事项
- 1. The device is not intended for clinical use including diagnosis, prognosis, and monitoring of a disease state, and it must not be used in conjunction with patient records or treatment. 2. This product contains Sodium azide (NaN3), a chemical highly toxic in pure form. At product concentrations, though not classified as hazardous, Sodium azide may react with lead and copper plumbing to form highly explosive build-ups of metal azides. Upon disposal, flush with large volumes of water to prevent metal azide build-up in plumbing. 3. As with any product derived from biological sources, proper handling procedures should be used.
- 注意事项
-
Avoid repeated freeze-thaw cycles.
Avoid exposure to light. - 储存条件
- 4 °C
-
- 抗原
- IgG3
- Abstract
- IgG3 产品
- 别名
- IgG3 Isotype Control, Immunoglobulin heavy constant gamma 3 Isotype Control, immunoglobulin heavy constant gamma 3 (G3m marker) Isotype Control, Ighg3 Isotype Control, IGHG3 Isotype Control
- 物质类
- Antibody
-
